Quick checks at the dock
- Squelch. Turn it all the way down. If you hear static, the receiver works. Turn it back up until the static just stops.
- Channel 16 at low power: ask for a radio check. Nearby boats and marinas answer. If they say you are broken or weak, the antenna side is the suspect.
- The antenna connector on the back of the radio. Unscrew it, look for corrosion, screw it back on tight.
- The antenna itself. A cracked base, a whip that has been folded down for years, or a coax that was stepped on will all kill range.
- Power. A radio that resets when you key the mic has a weak power connection; transmitting pulls far more current than receiving.
A proper antenna test
An SWR meter in the coax between the radio and the antenna tells you in a minute whether the antenna system is good. A high reading means the antenna, the cable or a connector is bad, and transmitting into it for long can damage the radio. A technician carries one; it is the first tool out of the bag for a VHF complaint.
DSC and the red button
Every fixed-mount VHF sold in years has a distress button that sends your position to the Coast Guard, but only if the radio has your MMSI number programmed and has a GPS position. Many boats have neither. If yours has never been set up, it is a ten-minute job that matters more than anything else on this page.
Questions people ask next
How far should a boat VHF reach?
Roughly line of sight: a fixed-mount radio with an 8-foot antenna on a center console typically reaches other boats at 5 to 10 miles and a tall Coast Guard antenna from further out. A boat that cannot raise the marina from the inlet has an antenna or cable problem, not a weak radio.
What is an MMSI number and how do I get one?
It is the identity number the radio sends with a distress call. In the US, recreational boaters that stay in domestic waters can get one free through BoatUS or a similar registry; boats that travel internationally need one from the FCC. It has to be programmed into the radio once, and the radio needs a GPS position to send with it.
Can I replace a VHF antenna myself?
Often, yes, if the mount and cable run are simple. The part people get wrong is the connector: a poorly made coax connector or one left unsealed fails within a season. If you are not comfortable soldering or crimping coax, have it done and tested with an SWR meter.