Boats at anchor at night, lit in warm gold with a teal glow on the water

Boat lighting installation and repair in Wilmington, NC

Kane Marine Systems installs and repairs boat lighting across New Hanover County: navigation lights that pass a safety check, accent lighting in full color, light bars for running at night, courtesy and deck lighting that works at the ramp in the dark, and the sealed wiring that keeps all of it working in salt.

When lighting needs a look

A boat at night with blue accent lighting across its hardtop and deck
  • A bow or stern light is out and you are not sure whether it is the bulb, the wire or the switch.
  • Lights flicker, dim, or only work when the boat is dry.
  • You launch or come in after dark and the deck and cockpit are black.
  • You want LED lighting that does not drain the battery at anchor.
  • You want accent lighting in full color, or a light bar for running at night.

How lighting work goes

Boat Lighting on a boat comes down to the jobs below, all of them done at the dock by Bill.

  • Find the fault, not the symptom

    Most dead lights are a corroded socket, a broken wire at the base or a bad ground. Those get fixed; the fixture gets replaced only when it is actually done.

  • Marine-rated, sealed, fused

    LED fixtures built for salt, heat-shrink connections, sealed wire entries, and a fused circuit sized for the load.

  • Switched where you want it

    On the helm panel, on a dimmer, or on a switch you can find in the dark. Lighting is only useful if you can turn it on.

Request a visit

Ask about lighting

Send what the boat is, what you want done and where it lives. Bill calls back to set a time.

  • The boat. Make, length, and the year if you know it.
  • The job. What you want done, or what stopped working.
  • Where it lives. Dock, marina, dry stack or trailer, and the town.

Quicker on the phone: (910) 200-8617

Request a visit

Bill calls you back to set a time. Calling is quicker: (910) 200-8617.

Questions about lighting

Which lights does a boat have to show at night?

Underway, a powerboat needs red and green sidelights and a white light visible all around, either one all-round light or a masthead light plus a stern light. At anchor it needs the white all-round light. A dead light is unsafe and a ticket.

Why do my lights only work sometimes?

Corrosion in a socket, a connector or a ground. Water gets in, the contact goes intermittent, and the light works until the boat gets wet. The fix is cleaning or replacing the connection and sealing it properly.

Do you install accent lighting and light bars?

Yes. Bill installs accent lighting in full color, and light bars, which are excellent for night navigation.

Do you do underwater lights?

Ask. Call Bill and describe what you want on the boat; he will tell you whether it is something he does.

Are LED navigation lights worth it?

Yes. Marine-rated LED fixtures draw a fraction of the power, last longer and are sealed better than the incandescent lights they replace. The one rule is to buy a fixture certified for navigation use; a cheap LED that is not certified can be the wrong color or brightness and still fails the rules.

Can you add courtesy or cockpit lighting to an older boat?

Yes. Courtesy, cockpit and spreader lights can be added to almost any boat. The work is running sealed wire to each fixture, fusing the circuit properly and putting the switch or dimmer where you can reach it at the helm.

Why did both sidelights go out at the same time?

One shared fault. Both sidelights usually run on one circuit and one ground at the bow, so a corroded ground, a broken wire or a blown fuse takes both out together. That is good news: it is one repair, not two fixtures.

Something on the boat not working?

Say what it is and where the boat is. Bill will tell you what it sounds like and when he can come.

Call (910) 200-8617