A Starlink dish seen up close on the edge of a boat hardtop

Starlink installation for boats in Wilmington, NC

Kane Marine Systems installs Starlink on boats in the Wilmington area and was one of the early Starlink installers here. The dish gets a solid mount with a clear view of the sky, 12-volt power straight from the boat with no inverter, and a network that reaches your phones, your displays and anything else on board.

Why owners are adding it

A Starlink dish mounted flat on the hardtop of a boat
  • Cell signal drops a few miles out and you want weather, radar and a phone that works.
  • You work from the boat, or the family does not come without Wi-Fi.
  • You want live weather and streaming on the chartplotter.
  • You already bought a kit and the stock router and power brick do not belong on a boat.
  • You run offshore and want a second way to reach someone besides the VHF.
  • You have a smaller boat and assumed Starlink needed an inverter.

What the install covers

Starlink Installation on a boat comes down to the jobs below, all of them done at the dock by Bill.

  • Mount it right

    Hardtop, T-top, radar arch or a dedicated pole. The dish needs sky, not a spot near the radar, and the mount has to take salt and pounding. Bill picks the spot with you.

  • Power it from the boat

    Starlink is now made in a 12-volt system, so the inverter is no longer needed. The dish runs straight from the boat’s power on its own fused circuit, which makes it a good fit for smaller boats too.

  • Put it on the network

    The router goes somewhere dry, the boat gets Wi-Fi where you actually sit, and your chartplotter can pull weather and updates over the connection.

Request a visit

Ask about Starlink

Send what the boat is, what you want done and where it lives. Bill calls back to set a time.

  • The boat. Make, length, and the year if you know it.
  • The job. What you want done, or what stopped working.
  • Where it lives. Dock, marina, dry stack or trailer, and the town.

Quicker on the phone: (910) 200-8617

Request a visit

Bill calls you back to set a time. Calling is quicker: (910) 200-8617.

Questions about Starlink

Does Starlink work offshore?

Yes, with the right plan. Starlink sells plans that cover coastal and open water; the standard residential plan does not. Which plan you need depends on how far out you go. Bill can explain the options, and the subscription stays in your name.

Which Starlink hardware works on a boat?

The flat high-performance dish is built for vehicles and boats and holds a connection while moving. The Mini is small, runs on 12 volts and also works in motion. The standard dish is meant for a fixed spot, so it suits the dock or anchor. Ask before buying a kit; the right one depends on how you use the boat.

Do I need an inverter to run Starlink on a boat?

No. Starlink is now made in a 12-volt system, so the inverter is no longer needed. The dish runs from the boat’s own power on a fused circuit, which makes it a good fit for smaller boats.

Where does the Starlink dish mount on a center console?

On the hardtop or T-top, on a radar arch, or on its own pole. It needs an open view of the sky and a spot clear of the radar beam, outriggers and antennas. Bill picks the spot with you on the boat, because every top is different.

Can Starlink feed weather to my chartplotter?

Yes, on displays that take an internet connection. Once the boat has Wi-Fi from the Starlink router, a compatible chartplotter can pull live weather, radar overlays and software updates over it. Bill sets that up as part of the install.

How much power does Starlink use on a boat?

Enough to matter at anchor. It depends on the dish: Starlink lists the Mini at roughly 20 to 40 watts and the flat high-performance dish at roughly 110 to 150 watts, so at 12 volts that is from about 2 amps to over 10, all day. That adds up without the engine running. A proper install puts it on its own fused circuit so you can switch it off, and a house battery or charger setup keeps it from draining the start battery.

How long does a Starlink install take?

Anywhere from two hours to a full day. It depends on the size of the boat and how easy it is to get to the wire channels.

If my Starlink stops connecting, do you come back out?

Yes. Call Bill and he will come back to the boat and sort it.

Should I take the Starlink dish off before a hurricane or a long haul-out?

No. The Starlink is permanently mounted and stands up to high winds, so it stays on the boat.

Something on the boat not working?

Say what it is and where the boat is. Bill will tell you what it sounds like and when he can come.

Call (910) 200-8617